Cooktop Repair in Newton, MA

The first job is reading how the cooktop was set up. We check the gas type label, the regulator and the flame at every burner before we order parts.

Flame that roars or lifts

A flame lifting off the burner or roaring at high output usually means the burner is getting too much gas for the air it has, or is set up for the wrong gas type. Cooktops shipped for one gas and converted for another need every orifice changed, and a missed one shows up as one burner behaving differently from the rest.

Burner not reaching maximum power is the opposite complaint. On a newly fitted cooktop, a supply line or connector that is too small for the total demand of the burners is often the cause, and we check it at the unit rather than replacing the valve.

Villages, houses and more than one appliance

Newton has no single downtown, so we plan routes by village: driveways around Waban, tighter two-family streets in Nonantum, and mill conversions at Newton Upper Falls. Access is rarely the difficulty for a cooktop.

Houses here often have a wall oven and a warming drawer beside the cooktop, and the same visit can cover all three if we have the model numbers in advance.

Before Thanksgiving

The fortnight before Thanksgiving is when a weak burner or a spark igniter electrode that has failed gets noticed, because every burner is running at once. Booking early in November leaves time to order parts.

A burner cap or head not seated after deep cleaning causes uneven, lifting flames, so check the caps sit flat before calling.