KitchenAid Stove Repair Near You — All Brands Serviced

That split decides the cost of any repair. We cross-reference the mechanical parts where they match and order boards and panels strictly to the KitchenAid model, which holds the bill nearer the mainstream than the nameplate might suggest.

Relay failures on the element circuit

On electric KitchenAid stoves with electronic controls, surface and oven elements are switched by relays on the control board. A relay that fails open leaves a zone cold; one that sticks closed leaves it roaring whatever setting you choose.

The element is measured first because it is the less expensive suspect. Only a good element with no power reaching it points back to the board.

Warming drawers and the space beneath

Many KitchenAid stoves carry a warming drawer in place of a storage drawer, with its own element and thermostat. A drawer that stays cold while the rest of the stove works is a separate, small fault, and one that gives off a burning smell often has something stored in it that shouldn't be there.

Keep plastics and paper out of a warming drawer entirely. If the smell persists with the drawer empty, the element or its wiring should be inspected.

Heavy doors, tired springs

KitchenAid oven doors are substantial, and over the years their hinge springs lose tension. A door that drops open or does not seal fully lets heat escape and forces the oven to run longer cycles to compensate.

Hinge springs are inexpensive and quick to replace on a freestanding unit. The sensor is tested at the same visit, since drift and heat loss produce similar complaints.